Automatic Urinal Flusher

As a  China manufacturer of Automatic Urinal Flusher,we are commited to develope Automatic Flusher which has Super Use of performance.our Automatic Urinal Flusher can effective avoid touching a result of cross-infection,

Today more and more families and work place  Pay more  attention to hygiene and Toilet bacteria,we are also the Manufacturer of Automatic Toilet Flusher , Toilet Ballcock, Mini Pilot Fill Valve, and Dual flush valve manufacturer

Model NO: Q-1

The Automatic urinal flusher have Intellectual mode,automatically determine the suitable amount of water,water-saving effect plus
1, user are between one minute preceding flush stop and only red back-flushing
2,user one minute apart,and the preceding flush stop and only red back-flushing
3,the user for a long time,smart mode,depending on the use of time,11 seconds after the flushing time to achieve the best cleaning result

The  Urinal sensor  have below features
1, Just use the two of DC AA Alkaline batteries,the market a rare design,easy to obtain,reduce energy consumption
2,Super use of performacne, 4000time ,about 3 years
3,Fine appearance,small size,the rare-texture design,compact size
4,High efficency fliter,the filter density is high ,and the dirty is not blocked,exclusively designed quick release type filter is easy to clean.easy to install
5, Water-saving save money
6 ,Sensor technology free to touch

Automatic Urinal Flusher product data
Usage tims: use lithium batteries can have 420000 times of flushing
flushing type: 2 times
Sensor range: 55cm±10
Sensor time: about 2 seconds
Pre-flushing : about 5 seconds
Final flushing: 6-15 seconds, automatic
inlet thread: 0.5-5kgf/cm2
product dimension: 111x56x137mm

we also have the automatic toilet flusher,please contact us .

a,User can stand in front of the Automatic Urinal Flusher  up to 50 cm
b, The flush action after 2 seconds ,flushing time is 5 seconds

c,The second flush action after you finish using the urinal toilet ,flushing time is 6-15 seconds,the system will automically determine the flushing time,due to different time and frequency of use.
Installation instruction

1, Push shell buckle O,Pulling up to remove the SHELL B
2,Unplug POWER LEADS/RED C,SOLENOID VALVE LEAD/RED AND BLACK I
3,Take out SCREW WATER PROOF PLUG D,unscrew and remove Battery cover E,Put in batteries with the correct polarity,and cover it up with batteries compartment F
4,Connecting Pipe Joint K with water inlet,make sure the are securely fixed
5,The attachment-accurately connect spiral pipe with URINAL COPPER CONNECTOR H, and sealing washer and nut after tighting, then puth the fixed flange on the urinal
6,Plug in power leads/red C, SOLENOID VALVE LEAD/RED AND BLACK I
7,When putting the sensor back to SHELL O,align the latch groove on left and right side,push in slowly,POWER LEADS/RED C,SOLENOID VALVE LEAD/RED AND BLACK I should be placed inside close to shell not at the bottom
8, place  back LOWER COVER N and lock it with The LOWER COVER SNAPS L to finish installation

We are your trusted Automatic Toilet Flusher manufacturer and our Automatic Flusher products are used by the global retailers. Partnering with us is quite easy. You can send us your Urinal or toilet tank or Dual Flush Valve design,we will recomend the most suitable product to your need.