Touchless Flush Kit for Flapper Valve Toilets Installation
hereby we will introduct how to install the Microwave controlled automatic toilet flush kit BQ18
A, Remove the cable from the line slot
B,Put the battery cable connectors,and take out the battery case.
C,Open the lid, fit 4aa alkaline batteries into the case according to marks of positive and negative(or replace the batteries)
D,Close the lid and installa back,then check operation
INSTALLATION
1,Install the bracket,inserting the tab in the right slot of bracket
2,Attach the chain to wheel on the control box
3,Position and install the control box in the water tank
4,Attach the chain to the flapper in the water tank,adjust the clip/chain and add or remove stack if needed(Confirm the flappper lift clear of the tank outlet when the chain connection on teh wheel is at the highest point,confirm the flapper is fully seled when the wheel chain attachment is at it’s lowest point)
6,Fit the battery case in the bracket at the side of control box
7, Connect the two cables
8,Fit the cable into the line slot
9,Stick the four pads on the fours corners of the tank rim
10,Close the tank cover
11,Stick the label on the right postion of tank cover